Übersetzung für "Statische höhe" in Englisch

The resulting statical height d is 44.0 cm.

Alternatively or additionally, the pressure increase can be achieved by static height or by vaporization and pressure buildup in a liquid containing tank.

Due to the massive weight reductions it is possible, for example in the construction of ceilings, to select thicker wall thicknesses (higher static height), so that the reinforcement can be reduced.

The pressure drop necessary for this is created by the static heighth of the suspension 23 in the supply container 12 between the liquid level 22 and the lower end of the discharge pipe 13.

The containers can be stacked on each another in the height and amount of storeys set up by the pertinent static calculation (usually – ground floor + 2 storeys).

The static level of brine in the pump well recorded was 0.135 m while the levels in the piezometers were recorded at 0.34 m in the Pz 5m hole and 0.83 cm in the Pz10m .

The static level of brine in the pump well recorded was 1.51m while the levels in the piezometers were recorded at 1. 2 0m in the Pz5m hole and 0.18m in the Pz10m.

Moreover, because of the large static height, the profiles of the main girder can be smaller and thus lighter than in a lattice or girder grid bridge.

For this purpose, optionally a pump (18) can be used or merely the static head of the upper part of the reactor is used as driving force.

The critical advantage of the invention as compared with the processes of the prior art is that, due to the additional static height in the accumulation chamber upstream of the entry into the substantially horizontal calibration gap, it is possible to homogenize the driving forces for relative flow as compared with the separator sheet over the width.

The static level of brine in the pump well recorded was 1.05 m while the levels in the piezometers were recorded at 1 m in the Pz5m hole and 0.96 cm in the Pz10m.

Through an inclined portion 28 of the discharge pipe 13 the suspension 23 is conducted to a higher portion 29 which forms the inlet for the centrifugal separator 14. The pressure drop necessary for this is created by the static heighth of the suspension 23 in the supply container 12 between the liquid level 22 and the lower end of the discharge pipe 13.

When they are used, a high static charge is produced.

Regulators with an I element have a very high steady-state accuracy.

This material has an extraordinarily high static and dynamic mechanical stability.

The rotary knife will generate high static charges on the lead and tail ends of the film.

Very high static charges are generated on the plastic web during the unwinding and rewinding process.

Optimization of all components results in the withstanding of high static and dynamic loads.

They are suitable for heavy static or alternating loads as well as shock loads.

This results in a high static and dynamic operating accuracy of the open controlled system.

For example, high static forces and dynamic alternating forces could act on the screw connection.

These control parameters are adjusted to the high steady-state gain of the continuous operating mode.

The adhesive film should have a static shear strength which is as high as possible.

ContiTech’s electrically conductive fuel hose prevents static buildup at high throughflow rates.

A service life of at least 20 years together with high static and dynamic strengths is often required.

The concealed gutters are also very suitable for a high static load.

High static charges are generated when packaging film is fed from a wind off roll.

They are designed for high static pull-out strength and for good dynamic running characteristics.