Übersetzung für "Teilekosten" in Englisch

These measures can be performed simply and quickly and involve no more than a small parts cost.

Ergonomics increases productivity and reduces parts costs.

This advantageously minimizes parts costs and the cost of assembly.

This has the advantage of a considerable reduction in parts costs and in the required variety of parts.

Accuracy and automation mean higher productivity at the lowest cost per part.

The result was a significant weight reduction with a simultaneous reduction in part costs.

The Part Costs (Budgeted) overview is opened.

To calculate the part costs, the following prices or costing values are used depending on the document assignment:

This increases productivity significantly and reduces part costs considerably.

This decreased part cost, accelerated delivery, and increased machine capacity.

The cell’s extremely high productivity ensures production at minimal cost per part.

Part costs can be determined with the standard preliminary costing only.

The system’s high productivity means you profit from lower cost per part.

You will reduce part costs because raw material is used completely.

The minimized reject rate leads to lowered parts costs.

The following values are determined for part costs during the project actual costing:

What effects does autonomy have on my part costs?

Part costs are marked by a " T ".

The result is a significant reduction in weight together with reducing direct costs.

This does not only cause substantial material and component expense during production and maintenance.

You save valuable time, work at full productivity and thus reduce part costs.

This results in a large number of different parts and small quantities for the various current levels, associated with high component costs.

Efficient fabrication on laser machines with high productivity and low part costs enable high-volume production at highly favourable prices.

With TruTops Calculate you always have these at hand. The software takes into account the machine hourly rate, overhead rate, employee qualification, average consumption, and technology data when calculating the part costs.

This in turn means an increased risk of leakage, so that apart from the parts costs the risk of the reject rates also increases.

Since in this case there is only a single main shut-off valve 38, this is designed for the maximum possible pressure medium demand of the actuating devices 13, 14 and is therefore of relatively large size, which results in relatively poor control properties such as delayed response behavior and the need for a large control current, relatively high component costs, and in most shift operations unnecessarily high mechanical loading of the control valves 22 a, 22 b, 32 a, 32 b .

The second axial rolling-contact bearing leads to an increase in the component part costs and in the manufacturing costs for a machine of this kind, and must also exhibit suitable adjustability characteristics.

In these solutions, a large number of different parts are required depending on the current level, and this leads to a wide range of parts, and high component costs associated with this.

A one-piece machined, heat treated ball reduces part costs and the thicker ball has improved durability.