Übersetzung für "Zu hoch eingestellt" in Englisch

I must have tuned the induction frequency too high.

If the waiting time is set too high you might waste online time whilst doing nothing (perhaps increasing your phone bill).

Make sure the suction's not too high.

Don't you think the air conditioner is turned up too high in here?

You should not set your sights too high either.

You have set the sensitivity TOO HIGH.

Maybe the retention time for spam and ciss queue is set too long.

The input Volume on your CURL telephony card may be set too high.

Driving with the volume too high may cause an accident.

Perhaps you have set the microphone sensitivity level too high.

Due to a programming error, Santa's standards were set too high... ... andheinvariablyjudgeseveryone to be naughty.

If, conversely, the casting temperature is set too high, porous spots occur in the moulded part during casting.

Make sure the speaker's volume level is not too high.

Before you sit down, make sure that the chair is not too high.

Should the extraction capacity be adjusted too high, the insufflator cannot maintain the abdominal pressure.

If the patient has inadvertently set the dose too high, he can reduce it again.

If the online steering response is adjusted too high, the vehicle will move in a tight 'S' shape along the wayline.

By processing the zirconia structures it is important not to set the revolutions per minute too high.

Regulating the capacity of heat and hot water pumps (which are often set too high).

If you set it too high you may end up paying most damages yourself.

If the ratio of light-sensitive groups per phosphazene molecule is too high, the products tend to self-cross-link.

This glare is especially a problem when the headlights are set on high beam and the vehicles are also equipped with high intensity halogen lamps.

However, it is preferably also possible for the pressure of the fluid jet to be increased only occasionally for cleaning the grinding surface and keeping it sharp, and thus to achieve the effect desired according to the invention. During the remainder of the grinding operation, the pressure can be reduced when the fluid also serves for feeding the coolant, in order to reduce the energy consumption and to avoid pronounced atomization of the coolant throughout the grinding.

In order to optimize the overall efficiency of the transmission because of unnecessary energy losses, the desired secondary pressure Ps,des can, however, not be set too high in block 202 but instead, in the ideal case, just so that no slippage occurs between the belt 9 and the conical pulleys.

It enables dosage setting in both directions; that is, if the patient has set the dose of his medicine too high, he can reverse the dosage setting again somewhat, which is not possible in the version of part c of FIG.

If the average power P should be adjusted too high, more pressurized fluid than is needed will be produced over the long term.

In conventional methods based exclusively on the setting of the first threshold value 103 a, one drawback is that if the threshold value 103 a has been set to be too low, a false alarm rate rises inadmissibly, whereas if the threshold value 103 a has been set to be too high, a detection rate for valid data transmission paths decreases.

Continuous up and down movements may result if the sensitivity of the tow-point displacement controllers is set too high.

The control unit also intervenes when one of the tow-point displacement controllers activates a continuous upwards and downwards movement, i.e. an oscillating tow-point behaviour, for instance if the sensitivity of the tow-point displacement controllers is set too high.